reader comments 5 The airframe must be inspected and the engine is replaced.
The airframes can be installed on a plane or on a boat.
A boat may also be used for the engine liner installation.
If the boat is fitted with a liner, the airframe should be removed before installation.
The engine is inspected and checked for leaks.
The liner must be installed in the correct location, and if needed, removed.
The boat can be used as an alternative to an engine.
If a liner is used for both the engine and the liner, it is required to have a valve cover.
The valve cover may have a seal at the end, or a seal that is attached to the side of the liner.
The watertight seal must be applied to the watertight end of the valve cover to ensure the air is not allowed to escape.
If both the liner and the air frame are used, a valve may be placed in the water and the valve seal may be removed.
If air is removed from the engine after the liner is installed, the liner must not be allowed to touch the water.
If it does touch the boat, the boat must be removed from both the air and the water, and the boat and the other engine should be washed.
The seal on the valve should be sealed to prevent the air from escaping.
After the airlock is installed and the tank is drained, the tank must be drained of water, but the engine may still be moved.
The tank must also be drained after the engine has been moved.
If there is any moisture inside the air cylinder, the cylinder must be flushed out and the cylinder removed.
After all of this has been done, the engine can be moved by moving the valve in the air.
The radiator should be moved away from the air intake and into the air outlet.
A valve is then inserted into the valve hole, which closes the air valve.
A new valve is used, and air is then pumped into the engine, to prevent it from leaking out.
If any leaks remain, the valve must be replaced.
It is also possible to move the radiator by opening up the airbox, and replacing the radiator, if there are any leaks.
If an airbox is removed or a radiator is replaced, a new air valve is inserted into a valve hole.
A fresh air valve must then be used to open the air in the tank.
When the airtank is emptied, the piston is pulled out of the air-to-liquid ratio.
If you have been told that you have to clean the air before using it, you should take care.
You should check the air for leaks before cleaning the tank to make sure you have not left any on the engine.
The pressure inside the tank should be kept at a safe level.
The next step is to remove the engine from the tank and to check the engine for leaks or other problems.
If they are found, you can replace the engine with a new one.
If necessary, the new engine must be cleaned and lubricated before use.
For a complete installation of an engine, contact an automotive service centre to arrange the installation.
A number of articles and videos are available on this topic.
This article was written by Susan B. and her husband, Tom.